/
Why is my cursor jumping to the nearest point when I’m doing a takeoff?
To open any link in a new tab, preserving your position in the current article, just hold down the <CTRL> key on your keyboard before clicking the link or click using your mouse wheel.
Why is my cursor jumping to the nearest point when I’m doing a takeoff?
- Jacob Oveson-Davis (Deactivated)
- Kristi Larson (Deactivated)
Owned by Jacob Oveson-Davis (Deactivated)
Last updated: Sept 27, 2019 by Kristi Larson (Deactivated)
This happens because you are in Snap mode. Snap mode is set to jump your cursor to the nearest point to assist in quicker takeoffs. If you need to set points close to other points and do not want this snapping action, simply click on Snap to turn off Snap.
, multiple selections available,
Related content
Why does my area takeoff stop on the second point?
Why does my area takeoff stop on the second point?
More like this
Settings Tab: Takeoff Tools
Settings Tab: Takeoff Tools
More like this
Why is my linear takeoff doubling my measurement?
Why is my linear takeoff doubling my measurement?
More like this
Home Tab: Digital Takeoff Tool Options
Home Tab: Digital Takeoff Tool Options
More like this
06. Takeoff
06. Takeoff
More like this
Settings Tab: Snapping
Settings Tab: Snapping
More like this
Copyright 2023 ConstructConnect