To open any link in a new tab, preserving your position in the current article, just hold down the <CTRL> key on your keyboard before clicking the link or click using your mouse wheel.
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Current »


Check Enable Snapping to Points to enable all selected snap options.

  • Checking Snap to PlanSwift Points will snap only to points created by the PlanSwift digitizers.
  • Checking Snap to CAD Points enable PlanSwift to snap to points created in CAD files.
  • Checking Hover to Snap Axis enables you to snap to a point, but if you hover at that point for a second or two the red snap box will turn green, thus locking on that axis.

Check Ortho to lock the digitizer on the 90 degree or 45 degree axes.

  •  Checking Smart Ortho allows a bit more refinement: snapping to the 90 or 45 degree axis only when you are within a few degrees of them.
  • No labels

Copyright 2023 ConstructConnect