/
Why does my area takeoff stop on the second point?
To open any link in a new tab, preserving your position in the current article, just hold down the <CTRL> key on your keyboard before clicking the link or click using your mouse wheel.
Why does my area takeoff stop on the second point?
This happens because you are in Record: Box mode, which requires only two points to form a box. If you don’t form a box when in Box mode then you will draw what looks like a line but is actually a box (with one side of the box on top of the other side). Box and Point To Point modes are visible at the bottom of the PlanSwift window only when Digitizer Record is on. The Record Mode button toggles between Box and Point-to-Point.
, multiple selections available,
Related content
Why is my cursor jumping to the nearest point when I’m doing a takeoff?
Why is my cursor jumping to the nearest point when I’m doing a takeoff?
More like this
Home Tab: Area Takeoff Tool
Home Tab: Area Takeoff Tool
More like this
Why is my linear takeoff doubling my measurement?
Why is my linear takeoff doubling my measurement?
More like this
Why does drawing around the same area give me different results?
Why does drawing around the same area give me different results?
More like this
Home Tab: Linear Takeoff Tool (Connected Segments)
Home Tab: Linear Takeoff Tool (Connected Segments)
More like this
Zone Tool Plugin (Organizing Takeoff into Zones)
Zone Tool Plugin (Organizing Takeoff into Zones)
More like this
Copyright 2023 ConstructConnect