On the Home Tab ribbon bar, you find Navigation and Zoom/Pan sections:
TheNavigation buttons move you backward and forward in thePagesyou have viewed (they only become active after you have viewed more than one Page).
Back returns you to through the Pages you previous viewed (not through the Pages list, but only through those Pages you actually viewed).
Forward (becomes active after moving "Back"), moves you forward in the list of viewed Pages (not necessarily through the Pages list).
The previous and next pages are not always the next in the list, the Back and Forward buttons work similar to a web browser's back/forward buttons. The buttons remain grayed out until you actually switch between pages.
This is very handy if you want to switch between two non-adjacent pages (such as a floor plan and its detail page).
You can move through the Page list by using the Page Up/Page Down keys on your keyboard.
Zoom / Pan:
Zoomallows you to select an area on your plans which will be zoomed to fill your screen area.
Fit Pagere-sizes the current plan to fit in the edit window (Page Size and Scaledisplays above the plan,Measurement Type below it).
Zoom Inzooms into the plan, centering on the center of your desktop. You can also zoom in by rolling the wheel on a wheel mouse up, or by pressing the + button on your keyboard.
Zoom Outzooms out of the plan, centering on the center of your desktop. You can also zoom out by rolling the wheel on a wheel mouse down, or by pressing the - button on your keyboard.
Pan,when selected, allows you to left-click on the plan and drag a different part of it into the current view. You can also pan by clicking and holding down the wheel on a wheel mouse.
Scrolling/Panning while Digitizing (drawing takeoff)
There may be times when you are digitizing or moving an item that the placement for the next node or the item is located out of the current view, you'll need to "pan" or "scroll" to the next point.
As your mouse nears the top, right, bottom, or left of the plan/takeoff screen, you see transparent blue blocks in the corner (see the Hover Scroll image, below).
Hover in a darker corner to move diagonally in the direction of the corner.
Hover over the top, bottom, or side blue bar to move vertically or horizontally toward the edge of the Page.
While scrolling, press theSpacebar to reverse the direction of the scroll (see theHover Scroll after Space Barimage below). This is useful if you went too far and don't want to move the mouse to the other side of the screen to scroll down.
Note: If you reach the edge of the PlanSwift drawing area, you will be presented with red boxes instead of blue; this means that you cannot scroll anymore in that direction.
Wheel Mouse Pan
Hold your wheel mouse button down and "drag" the plan.
Release the button to continue digitizing, or repeat step 1 to pan some more.
The Zoom/Pan tool ( lower-left corner of the edit window) toggles a small window that shows a preview of the current Page and a shaded box that represents what you are currently seeing in the edit/image window.
Within this mini-window, you can move the shaded box to change what you see in the edit/image window.
You can also roll your scroll mouse wheel forward/backward to zoom in and out.
Double-click to center the view box on the point where you double-click.
Toggle the Zoom/Pan tool closed and reopen it whenever you like.
On the right and the bottom of the current view, you see scrollbars, unless you are viewing the page at a zoom level that fits the entire page within the edit/image window.
Click and drag these scrollbars to move around the plan.