Duct 4.1.2.3 Release Notes

The 4.1.2.3 release includes the below bug fixes. The purpose of this release was to provide a Hot-Fix release to provide a solution for reported bugs.

Bug Fixes and Corrections

All items listed below have been corrected

• While copying zones that contained round tees, crosses, taps, or reducers could become corrupt. Users would receive an error when attempting to open the zone. The issue has been corrected and should no longer receive errors.

• Catalog items that only contained a length would cause an error while exporting to the Duct Summary reports. If users had taken off items with only a length (Ie; T-Stat wire, linear slot diffusers, conduit, etc) the operation to export those items to excel would give an error. The issue has been corrected and will no longer error.

• After copying a zone and selecting a new item the dimensions were not being populated from the last item in the Audit Trail. This issue has been corrected and all sizing should flow from the last item to the next item.

• Exporting reducing items from the catalog to the Duct Summary reports would show the dimensions in a date format. This has been corrected to properly show the dimensions of the reducing items.

• Selecting duct and changing the length to less than a standard length and clicking accept would prompt the user that items with no length are not allowed. This issue has been corrected to allow manual accepting of less than a standard length of duct.

• Creating an assembly that contained a round tee, cross, tap, or reducer and then deleting the original item used to create the assembly would delete that item from the assembly as well. The user would get an error attempting to use the assembly. This issue has been corrected to ensure the items within the assembly are not deleted or modified.